Teac CD-RW750 Manuel d'utilisateur télécharger pdf (Page 26)

5 – After recording

26 TASCAM CD-RW750 Owner’s Manual

Erasing tracks

It is possible to erase the last recorded track, the last

two recorded tracks, the last three recorded tracks,

etc. It is not, however, possible to erase tracks in the

“middle” of the disc.

1 With the disc loaded, and the unit in stop

mode, press the

ERASE key (G or D).

2 If the display does not show ERASE XX-

XX?

, where XX is the number of the last

track recorded on the disc, turn the

MULTI

JOG

control B or use the SKIP keys I until

it is displayed.

3 Turn the MULTI JOG control or use the SKIP

keys to change the number of the first track to

be erased. The highest value that this number

can take is the last track recorded (e.g. if 17

tracks have been recorded on the disc,

17-

means that the last track only, 17, will be

erased). The lowest value that this number can

take is

2 (if this number was 1, the whole disc

would be erased, as described below).

NOTE

If only one track has been recorded on the disc, only the

“erase disc” option (“Erasing a whole disc” on page 26)

is available.

4 When the range of tracks to be erased has

been selected, press the

MULTI JOG control or

press the

ENTER key 7.

NOTE

This operation cannot be undone. If you are going to

erase a track or tracks, make sure that they are record-

ings that you really want to erase!

5 If you do not want to proceed with the erase

operation, press any other key (such as the

STOP key).

6 If the erase operation has been selected, the

word

ERASE flashes on the display, and the

timer starts counting down from

0:20 (20

seconds).

7 At the end of the countdown period, the word

Complete appears briefly on the display,

and the display returns to the track/time

display.

Erasing a whole disc

When you want to erase a whole disc (all the tracks

on a disc), follow the procedure below:

1 With the disc loaded, and the unit in stop

mode, press the

ERASE key (G or D).

2 Turn the MULTI JOG control B or use the

SKIP

keys I until the display shows ERASE

DISC?

3 To erase the contents of the disc, press the

MULTI JOG control or press the ENTER key

NOTE

This operation cannot be undone. If you are going to

erase a disc, make sure that it contains only recordings

that you really want to erase!

4 If you do not want to proceed with the erase

operation, press any other key (such as the

STOP key).

5 If the erase operation has been selected, the

word

ERASE flashes on the display, and the

timer starts counting down a time value shown

on the display.

6 At the end of the countdown period, the word

Complete appears briefly on the display,

and the display returns to the track/time

display.

Refreshing a disc

If a CD-RW disc has been corrupted at any point (e.g.

power has been cut off in the middle of a finalize

operation, etc.), or has been used in a computer or

another piece of equipment that makes it unreadable,

it is possible to “refresh” the disc to make it usable

again. This is equivalent to formatting a disk on a

computer to prepare it for use. This operation

destroys all data on the disc.

1 2 ... 21 22 23 24 25 26 27 28 29 30

Commentaires sur ces manuels

Pas de commentaire

Teac CD-RW750 Manuel d'utilisateur Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Teac CD-RW750