Teac DV-W14R Manuel d'utilisateur télécharger pdf (Page 36)

12.3 Read Error Skip

28 Rackmount DVD/CD Duplicator User’s Manual

12.3 Read Error Skip

The

Read Error Skip setting controls error skipping during reading of the source

disc.

If the setting is

OFF and an error is detected, the target drive stops and displays

the read error message.

If the setting is

ON, no messages will be displayed if an error occurs. The copy

operation will be completed and the copy will include all errors detected during

the process.

The default setting is

OFF.

12.4 Format HDD

(For factory use only; please do NOT use this function.)

The factory-installed hard disk drive has already been partitioned and formatted

and is ready for use.

12.5 Verify HDD

(For factory use only; please do NOT use this function.)

The factory-installed hard disk drive has already been partitioned and formatted

and is ready for use.

12.6 Burn-in

The

Burn-in function runs an emulate writer function continuously. The disc in the

target drive is ejected and re-inserted automatically between each test cycle. This

function can be prepared to run continuously or specified to run from 1 to 1000

times.

12.7 Update Firmware

The

Update Firmware function updates the firmware of the interface board via a

CD or DVD disc. The disc must contain the required data file and be inserted in

the source drive. The DVD/CD Duplicator will locate the data and update its

firmware automatically. During the update, do not turn off the power to the unit.

The update process is complete after the system resets automatically and displays

the main menu.

Warning! Do not run this function. It will erase all data already loaded into disk

partitions. This function is reserved for factory use only.

Warning! Do not run this function. It will erase all data already loaded into disk

partitions. This function is reserved for factory use only.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Pas de commentaire

Teac DV-W14R Manuel d'utilisateur Page 36